Airbus A320neo Upgrade

[Sven M J]

Changelog :

• Removed INOP property from all ECAM page buttons
• Added APU ECAM page
• Added Door ECAM page
• Added Bleed ECAM page placeholder
• Fixed fuel consumption
• Fixed APU startup time
• Added MODE change indication to Navigation Display
  
  
   

 

[Sven M J]

V0.2.0

AdenFlorian released this 6 hours ago · 311 commits to master since this release

Added

• [ADIRS] Added ADIRS knob functionality
• [ADIRS] Added ADIRS ALIGN light functionality
• [ADIRS] IRS alignment affects PFD and MFD displays and indicators
• [ADIRS] IRS alignment affects TAT and SAT indicators on lower ECAM
• [ADIRS] IRS alignment time dependent on latitude
• [ADIRS] IRS alignment time remaining displays on upper ECAM
• [BRAKES] Brake gauge now properly reflects status of toe brakes and parking brakes
• [CHRONO] Added basic chronometer functionality
• [ECAM] Added full APU Bleed functionality to APU ECAM page
• [ECAM] Added F/CTL ECAM page with support for elevator, aileron, and pitch trim movements
• [ECAM] F/CTL ECAM reflects current ELAC and SEC status
• [ECAM] Lower ECAM automatically switches to DOOR page when a door is opened
• [ECAM] Lower ECAM automatically switches to APU page when APU master is switched on
• [ECAM] Added ECAM memos 'OVERSPEED', 'GND SPLRS ARMED', 'SEAT BELTS', and 'NO SMOKING'
• [MFD] Added range change indicator to navigation display
• [MFD] Added GPS status to navigation display
• [MISC] PFD, MFD, and ECAM displays now present a self-test upon powering up
• [MISC] PFD, MFD, ECAM, and MCDU displays no longer work only on battery - require external power or APU/engine generators
• [MISC] Added seatbelt sign switch functionality
• [MISC] Added no smoking sign switch functionality (full range of motion currently restricted)
• [MISC] Added moveable dummy knobs for cockpit, fwd, and aft cabin air conditioning controls
• [MISC] Added full (non-interactive) checklist
• [SOUND] Added chimes for seatbelt and no smoking switches

Changed

• [APU] APU start and flap logic adjusted
• [APU] APU EGT is now adjusted for ambient temperature
• [APU] Smoothened APU EGT curve
• [APU] APU bleed now momentarily drops when bleed valve is opened
• [BRAKES] Fixed accumulator pressure changing when on battery
• [BRAKES] Autobrake is now off when starting cold-and-dark
• [ECAM] APU gen arrow now only shows when APU connected to bus
• [ECAM] APU 'FLAP OPEN' no longer displays instantly but reflects actual flap opening time
• [ECAM] Bleed ECAM page implemented
• [ECAM] Initializes on DOOR page instead of FUEL
• [ELEC] Battery display is now always on and displays battery voltage instead of main bus voltage
• [FCU] Altitude selection knob no longer requires explicit push/pull interaction to update new altitude target
• [FCU] Increased size of managed mode indicators
• [FCU] Adjusted alignment of altitude and vertical speed displays
• [FMA] Corrected '1FD2' to '1 FD 2' on FMA
• [FMA] Fixed 'SPEED' appearing whilst on the ground and A/THR requiring AP
• [FMA] Fixed various issues with thrust modes appearing incorrectly
• [FMA] Fixed thrust modes appearing when in GS or VS modes
• [FMA] Fixed 'SRS' appearing as armed, fixed 'SRS' disengagement conditions
• [FMA] 'SPEED' no longer appears with autopilot/auto-throttle disengaged
• [FMA] 'NAV', 'CLB', and 'DES' no longer appear with flight directors disabled
• [FMA] Fixed 'SPEED' and 'MACH' flickering at cruise
• [FMA] Improved 'OP DES' and 'OP CLB' trigger logic
• [FMA] Fixed 'CLB' and 'DES' appearing at incorrect times as well as on ground
• [FMA] Fixed 'NAV' not appearing with AP disengaged
• [FMA] Fixed 'ALT' in blue not appearing when changing altitudes
• [FMA] Fixed 'ROLLOUT' appearing after leaving the runway
• [FMA] Fixed 'GS' appearing with no FD's active
• [FMA] Fixed 'A/THR' appearing enabled on the ground
• [FMA] Fixed 'MACH' appearing on the ground
• [FMA] Fixed 'SPEED' and 'MACH' not appearing in some situations
• [FMA] Fixed 'THR LVR' and 'THR IDLE' not appearing in some situations
• [FMA] Decreased sensitivity for 'THR CLB' appearing on the FMA.
• [FMA] Fixed 'THR IDLE' not appearing when descending
• [FMA] Fixed 'THR LVR' appearing when in cruise phase
• [FMA] Fixed 'SPEED' not appearing with AP off but A/THR on
• [FMA] Fixed AP and FD FMA modes appearing green instead of white.
• [FMA] Fixed 'FINAL APP', 'LAND', 'FLARE', 'ROLLOUT' appearing with FD off
• [FMA] Fixed a situation where 'SPEED' wouldn't appear
• [FMA] Fixed 'HDG' appearing when on the ground
• [FMA] Fixed 'SINGLE' and 'DUAL' not appearing on ILS approaches
• [FMA] Fixed 'CAT' not appearing on FMA, improved logic to match ICAO criteria
• [FMA] Corrected logic for engaging ILS categories
• [FMA] Improved A/THR FMA modes logic.
• [FMA] Improved logic for 'CAT' modes on ILS approaches
• [FMA] Added support for 'ALT G/S' armed FMA mode
• [FMA] Improved CAT logic on FMA
• [LIGHTS] Brightness knobs for PFD, MFD, ECAM, FCU, and overhead panel are turned down when spawning cold-and-dark
• [LIGHTS] Reduced ambient cockpit lighting
• [LIGHTS] Change minimum brightness to 0 on all displays
• [MISC] Improve phase change logic
• [MISC] Change initial FLT states
• [MISC] Fixed engine selector on crank when starting in-flight or on approach
• [MFD] Adjusted look of wind arrow on navigation display
• [PERF] Overpowered engine thrust reduced
• [PERF] Fuel consumption improved
• [TEXTURES] Adjusted textures for panels, pedestal, and cockpit decals
• [TEXTURES] Adjusted colors on overhead panel

Removed

• [LIGHTS] Taxi light no longer bleeds into cockpit
• [SOUND] Removed 70ft and 60ft radio altimeter callouts
• [SOUND] Removed overspeed voice warning (master warning chime will still play)
  
  https://github.com/flybywiresim/a32nx/releases/tag/v0.2.0
   

[Sven M J]

Kan en admin flytte emne til MSFS2020 - Utvikling?

[Jan R. Storelvmo]

Det er gjort

[Sven M J]

Kan være lurt å følge med på siden dems, siden det kommer ofte oppdateringer til Neo'en

http://www.flybywiresim.com/